38
[Description]
• This parameter is used for selecting the number of decimal
point positions for the process value (PV) .
Decimal point position (Settings: 0 / 1 / 2)
Related parameters:
(page 36)
(page 36)
[Setting example] Changing the decimal point position setting from 0 to 1
"0" (No digit after decimal point)
"1" (1 digit after decimal point)
"2" (2 digits after decimal point. This is valid only for the voltage and current inputs)
Press the key once. will be displayed and will be registered for . After that,
the controller will operate with one decimal point position displayed.
Press and hold the key for three seconds.
will be displayed.
Press the keys to flicker and to display .
(Repeat the procedure from 3 to 5 to check the set value.)
Press the key once.
The current setting ( ) will be displayed.
Press the key to display .
SEL
SEL
SEL
1.
4.
If you want to display the operation status, press and hold the key for two seconds.
The SV will be displayed on the display area.
If unoperated state continues, the PV will be displayed.
6.
2.
3.
SEL
5.
Display Operating procedure
PV indication
PV indication
SV indication
To Next Page
Loading...
