Fuji Electric PXR3 - Parameter Display Mask

69
[Description]
• This parameter skips the parameter display by items.
• This parameter is used not to display the items that are
not used, or not to change the settings mistakenly.
to
to Parameter display mask (Setting range: 0 to 255)
[Setting example] Skipping "I" and "d"
Setting "4+8=12" according to the code table of dSP3
• "Parameter mask DSP" in "2-1 Parameter list" (page 6)
shows which parameter is skipped by setting to
and to .
• Set the total value of the codes of the item that you want
to skip.
If you want to display the operation status, press and hold the key for two seconds.
The SV will be displayed on the display area.
Press and hold the key for five seconds.
will be displayed.
Press the key once. will be displayed and will be registered for .
After that, the parameters of and will be skipped, and will not be displayed.
Press the or keys to flicker and display .
(Repeat the procedure from 3 to 5 to check the set value.)
If unoperated state continues, the PV will be displayed.
Press the key once.
The current setting ( ) will be displayed.
Press the key to display .
SEL
SEL
SEL
1.
4.
6.
2.
3.
SEL
5.
Display Operating procedure
PV indication
PV indication
SV indication