58
,
Output value display (Display only: -3.0 to 103.0%)
[Description]
• These parameters display the output values of outputs 1
and 2 in the unit of %. (Since the values are calculated
with the software, they may have some error comparing
to the actual output.)
[Setting example] Confirming the output value (the calculated value) of control output 1
Press and hold the key for five seconds.
will be displayed.
Press the key once.
The output value will be displayed.
Press the key to display .
SEL
SEL
SEL
1.
If you want to display the operation status, press and hold the key for two seconds.
The SV will be displayed on the display area.
If unoperated state continues, the PV will be displayed.
2.
3.
4.
Display Operating procedure
PV indication
PV indication
SV indication
To Next Page
Loading...
