22
Derivative time (Setting range: 0.0 to 999.9 seconds)
[Description]
• can be set automatically by the auto-tuning operation.
•
can also be set manually.
[Setting example] Changing the differential time from 60.0 seconds to 50.0 seconds
• When
is set to 0, the differential operation does not start.
• When
is set to 0.0, this makes the setting of
ineffective.
Press the key once. will be displayed and 50.0 seconds will be registered for . After that,
the controller will operate with being 50.0 seconds.
Press and hold the key for three seconds.
will be displayed.
Press the or keys to flicker and to display .
(Repeat the procedure from 3 to 5 to check the set value.)
Press the key once.
The current setting ( ) will be displayed.
Press the key to display .
SEL
SEL
SEL
1.
4.
If you want to display the operation status, press and hold the key for two seconds.
The SV will be displayed on the display area.
If unoperated state continues, the PV will be displayed.
6.
2.
3.
SEL
5.
Display Operating procedure
PV indication
PV indication
SV indication
To Next Page
Loading...
