Fuji Electric PXR3 - Parity for Communication

65
[Description]
• This parameter sets the parity for communications.
The baud rate is fixed at 9600bps.
: Odd parity
: Even parity
: No parity
Parity for communication (Setting range: 0 to 2) (Option)
[Setting example] Setting the even parity
Press the key once. will be displayed and the even parity will be registered for .
However, it does not switch to the even parity at this point.
Press and hold the key for five seconds.
will be displayed.
Press the or keys to flicker and to display .
(Repeat the procedure from 3 to 5 to check the set value.)
Press the key once.
The current setting ( ) will be displayed.
Press the key to display .
SEL
SEL
1.
4.
Power off the PXR3, and then on. The even parity is set now.

7.
6.
2.
3.
SEL
5.
Display Operating procedure
PV indication
PV indication
SV indication
If unoperated state continues, the PV will be displayed.
If you want to display the operation status, press and hold the key for two seconds.
The SV will be displayed on the display area.
SEL