Fuji Electric PXR3 - Page 52

52
[Setting example] Setting the delay time for ON-delay alarm to 30 seconds
Press the key once. will be displayed and seconds will be registered for .
After that, the controller will operate with being 30 seconds.
Press and hold the key for five seconds.
will be displayed.
Press the or keys to flicker and to display .
(Repeat the procedure from 3 to 5 to check the set value.)
Press the key once.
The current setting ( ) will be displayed.
Press the key to display .
SEL
SEL
SEL
1.
4.
If you want to display the operation status, press and hold the key for two seconds.
The SV will be displayed on the display area.
If unoperated state continues, the PV will be displayed.
6.
2.
3.
SEL
5.
Display Operating procedure
PV indication
PV indication
SV indication