Fuji Electric PXR3 - Page 55

55
[Setting example] Setting the error status alarm function for Alarm 2 to ON
Press the key once. will be displayed and the main unit input error alarm function for
Alarm 2 will be turned ON. After that, the controller will operate with the error status alarm
function for Alarm 2 being ON.
Press and hold the key for five seconds.
will be displayed.
Press the or keys to flicker and to display .
(Repeat the procedure from 3 to 5 to check the set value.)
Press the key once.
The current setting ( ) will be displayed.
Press the key to display .
SEL
SEL
SEL
1.
4.
If you want to display the operation status, press and hold the key for two seconds.
The SV will be displayed on the display area.
If unoperated state continues, the PV will be displayed.
6.
2.
3.
SEL
5.

Display Operating procedure
PV indication
PV indication
SV indication