Fuji Xerox D110

Printing and Deleting Stored Jobs
311
Job Status
10
2 Enter the user ID, and select [Enter].
Note • When the passcode is set, enter the user
ID and select [Next]. Then, enter the
passcode and select [Enter].
• While the user is authenticated, the <Log
In/Out> button lights up on the control
panel.
• To log out of the machine, press the <Log
In/Out> button on the control panel.
3 Select [Private Charge Print].
Note • If you are authenticated as a system administrator, selecting [Private Charge Print] will
display a list of authentication user IDs. Select a user ID from the list, and then select [Job
List] to display a list of jobs stored for the selected user.
4 Select the job to be printed or deleted.
Note • You can select up to 100 files
simultaneously to print or delete the files.
If you select multiple files, they are printed
in the selected order.
5 Select any option.
6 When printing, specify the number of print
sets using the numeric keypad.
Select All
Selects all jobs. To deselect all the jobs, select this button again.
Delete
Deletes the Private Charge Print job.
Note • If jobs with the same user ID are all deleted, the user ID will be deleted.
Refer to "When [Delete] is Selected" (P.311).
Print Quantity
Specify the number of print sets using the numeric keypad.
Print
Prints the Private Charge Print job. After printing, the job is deleted.
Refer to "When [Print] is Selected" (P.312).
When [Delete] is Selected
1 Select [Delete].
Delete
Deletes the job.
Important • Once the job is deleted, it cannot be restored.
Cancel
Cancels deleting the job.