Error Code
427
Problem Solving
14
016-517
O [Cause] There is an error in the content described in the PostScript
file.
[Remedy] Print with the PostScript driver. Furthermore, modify
ProcessColorModel described in the PostScript file so that
the color mode does not change.
016-518
O [Cause] PS booklet and WaterMark were specified at the same
time.
[Remedy] Specifying a combination of PS booklet and WaterMark/
UUID is not possible. Cancel one of them.
016-519
O [Cause] The number of pages reached the maximum number of
pages specified, and the print job is terminated.
[Remedy] Have your system administrator change the maximum limit
of printable pages.
016-520
O [Cause] An error occurred in the high compression hardware.
[Remedy] Execute the operation again. Also change the output file
format and color mode.
If the problem is not resolved, switch off the machine
power, make sure that the touch screen is blank, and then
switch on the machine power. And then perform the above
operation again.
If the error still is not resolved, contact our Customer
Support Center.
016-522
O [Cause] LDAP server SSL authentication error. Unable to acquire
an SSL client certificate.
[Remedy] The LDAP server is requesting an SSL client certificate.
Set an SSL client certificate on the machine.
016-523
O [Cause] LDAP server SSL authentication error. The server
certificate data is incorrect.
[Remedy] The machine cannot trust the SSL certificate of the LDAP
server. Register the root certificate for the LDAP server's
SSL certificate to the machine.
016-524
O [Cause] LDAP server SSL authentication error. The server
certificate will expire soon.
[Remedy] Change the SSL certificate of the LDAP server to a valid
one. You can clear this error by selecting [Disabled] for
[LDAP - SSL/TLS Communication] under [SSL/TLS
Settings] on the machine; however, note that selecting this
option does not ensure the validity of the LDAP server.
016-525
O [Cause] LDAP server SSL authentication error. The server
certificate has expired.
[Remedy] Change the SSL certificate of the LDAP server to a valid
one. You can clear this error by selecting [Disabled] for
[LDAP - SSL/TLS Communication] under [SSL/TLS
Settings] on the machine; however, note that selecting this
option does not ensure the validity of the LDAP server.
Error Code
Category
Cause and Remedy
CPFSMO
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.