14 Problem Solving
488
Problem Solving
14
116-710
O [Cause] The correct document size could not be judged because
the receive data exceeded the HP-GL/2 (optional) spool
size.
[Remedy] Increase the size assigned to HP-GL/2 auto layout
memory.
116-713
O [Cause] The job was divided to be printed because of insufficient
disk space.
[Remedy] Delete unnecessary data from the hard disk to free up disk
space.
116-714
O [Cause] An HP-GL/2 (optional) command error occurred.
[Remedy] Check the print data.
116-720
O [Cause] An error occurred during print processing because of
insufficient memory.
[Remedy] Stop unnecessary ports or delete unnecessary data to free
up disk space.
116-725
O [Cause] Failed to write the image log because the image log
storage area on the machine is insufficient.
[Remedy] Execute the operation again.
If this error still is not resolved, take one of the following
measures:
z
Delete unnecessary image logs.
z
Change the [Assurance Level] setting for image logs to
[Low].
In this case, selecting [Low] does not secure the contents
of created image logs.
116-740
O [Cause] A numerical value operation error occurred because a
value exceeding the value limit of the machine was used in
the print data.
[Remedy] Check the print data.
116-747
O [Cause] The paper margin value is too large for the HP-GL/2
(optional) active coordinates area.
[Remedy] Decrease the paper margin value, and then execute the
operation again.
116-748
O [Cause] There is no plot data in the HP-GL/2 (optional) print data.
[Remedy] Check the print data.
116-749
O [Cause] The job was cancelled because the specified font does not
exist.
[Remedy] Install the font, or set the print driver to replace the font.
116-750
O [Cause] Banner sheet tray malfunction
[Remedy] Restore the tray to normal condition or change the Banner
sheet tray.
116-752
O [Cause] The descriptions of the PDF or XPS printing job ticket have
a problem.
[Remedy] Execute the operation again. If the error still is not
resolved, contact our Customer Support Center.
Error Code
Category
Cause and Remedy
CPFSMO
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
