148 5 Control Panel Settings
PJL Sets whether to enable or disable PJL commands that are sent from the
computer.
PJL commands control print jobs, and are required to print jobs using the print
driver. Use of PJL commands allows you to specify the language emulation for
the next job while another language emulation is being processed by the
printer. (See *5 on P. 214.)
• [Enabled] (default)
•[Disabled]
Adobe Protocol Sets the PostScript communication protocol.
• [Normal] (default)
Select this when the communication protocol is in ASCII format.
•[Binary]
Select this when the communication protocol is in binary format. Some data
is printed slower than with the [Normal] protocol.
•[TBCP]
Select this when the communication protocol is both in the ASCII and binary
formats, and switches between the two using control codes.
Note
• Select an appropriate option according to the data format specified on your
print driver.
• [Adobe Protocol] is enabled only when printing in PostScript.
Auto Eject Time Sets the time that data still remaining on your printer is automatically printed
and ejected when data has continuously not been received.
Set the time from 5 to 1275 seconds in 5-second increments. Jobs are judged
as finished when the next data is not received within the time set here, after the
last data has been received. (See *2 on P. 214.)
• [30 Seconds] (default)
Bi-directional Sets whether or not to enable bi-directional parallel communication
(IEEE1284).
• [Enabled] (default)
•[Disabled]
Setting Description
To Next Page
Loading...
Need help?
General
