5.2 Common Menus Setting 149
[LPD]
Network/Port
LPD
LPD
Port Status
LPD
Print Mode
LPD
PJL
LPD
Connect Time-Out
LPD
TBCP Filter
LPD
Port Number
LPD
Maximum Sessions
LPD
Print Queue
Setting Description
Port Status Sets whether to enable or disable the LPD port at printer start-up.
• [Enabled] (default)
•[Disabled]
Note
• The IP address must be set to enable the LPD port.
Important
• If the printer runs out of memory when the port is enabled, the port is
sometimes automatically disabled. If this happens, either disable unused
ports, or change the memory allocation under [Allocate Memory].
Print Mode Sets the method of processing data (language emulation).
• [Auto] (default)
After receiving data from a computer, the printer automatically detects its
language emulation and processes the data accordingly.
(See *1 on P. 214.)
• [PS] [ESCP] [HP-GL/2] [PCL] [TIFF] [KS] [KSSM] [KS5895]
After receiving data from a computer, the printer processes the data with the
selected print language.
•[HexDump]
Allows you to view data received from a computer by printing it in ASCII code
(hexadecimal format). (See *3 on P. 214.)
PJL Sets whether to enable or disable PJL commands that are sent from the
computer.
PJL commands control print jobs, and are required to print jobs using the print
driver. Use of PJL commands allows you to specify the language emulation for
the next job while another language emulation is being processed by the
printer. (See *5 on P. 214.)
• [Enabled] (default)
•[Disabled]
To Next Page
Loading...
Need help?
General
