EasyManua.ls Logo

Fuji Xerox DocuPrint C5005 d

Fuji Xerox DocuPrint C5005 d
462 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
150 5 Control Panel Settings
[NetWare]
Connect Time-Out Sets the time after which data reception is canceled if data is not received.
Specify the value from 2 to 3600 seconds in 1-second increments. (See *2 on
P. 214.)
[16 Seconds] (default)
TBCP Filter Sets whether to enable or disable the TBCP filter during processing of
PostScript data.
[Disabled] (default)
[Enabled]
Port Number Sets the port number from 1 to 65535. (See *2 on P. 214.)
[515] (default)
Note
Set only unique port numbers.
Maximum Sessions Set the maximum number of clients that can connect to the printer
simultaneously by LPD. Specify the value from 1 to 10.
[5] (default)
Print Queue Sets the print data queue.
[Data Process Order] (default)
The printer prints print data in the order that it is processed.
[Job Submit Order]
The printer prints print data in the order that it is received.
Network/Port
NetWare
NetWare
Port Status
NetWare
TransportProtocol
NetWare
Print Mode
NetWare
PJL
NetWare
No. of searches
NetWare
TBCP Filter
Setting Description
Port Status Sets whether to enable or disable the NetWare port at printer start-up.
[Enabled]
[Disabled] (default)
Important
If the printer runs out of memory when the port is enabled, the port is
sometimes automatically disabled. If this happens, either disable unused
ports, or change the memory allocation under [Allocate Memory].
Setting Description

Table of Contents

Related product manuals