5.2 Common Menus Setting 151
TransportProtocol Sets the protocol of the transport layer used by NetWare. Either or both of IPX/
SPX and TCP/IP can be selected.
• [TCP/IP, IPX/SPX] (default)
•[TCP/IP]
• [IPX/SPX]
Note
• When using TCP/IP protocol, both the printer and client computers must
have IP addresses.
Print Mode Sets the method of processing data (language emulation).
• [Auto] (default)
After receiving data from a computer, the printer automatically detects its
language emulation and processes the data accordingly. (See *1 on P. 214.)
• [PS] [ESCP] [HP-GL/2] [PCL] [TIFF] [KS] [KSSM] [KS5895]
After receiving data from a computer, the printer processes the data with the
selected print language.
•[HexDump]
Allows you to view data received from a computer by printing it in ASCII code
(hexadecimal format). (See *3 on P. 214.)
PJL Sets whether to enable or disable PJL commands that are sent from the
computer.
PJL commands control print jobs, and are required to print jobs using the print
driver. Use of PJL commands allows you to specify the language emulation for
the next job while another language emulation is being processed by the
printer. (See *5 on P. 214.)
• [Enabled] (default)
•[Disabled]
No. of searches Sets the number of times that the file server is searched.
Set from 1 to 100 in “times” units or [No Limit]. Searches are performed at 1-
minute intervals. (See *2 on P. 214.)
• [No Limit] (default)
• [1 Time(s)] to [100 Time(s)]
TBCP Filter Sets whether to enable or disable the TBCP filter during processing of
PostScript data.
• [Disabled] (default)
• [Enabled]
Setting Description
To Next Page
Loading...
Need help?
General
