Fuji Xerox DocuPrint C5005 d User Manual

154 5 Control Panel Settings
[EtherTalk Compat]
DNS Sets whether or not to use the name registered to the DNS (Domain Name
System) when identifying the printer.
• [Enabled] (default)
The DNS name is used.
•[Disabled]
The IP address is used.
Added Port
Number
Sets the additional port number from 1 to 65535. (See *2 on P. 214.)
• [80] (default)
Note
• Set only unique port numbers. Note, however, that InternetServices/IPP/
SOAP/UPnP/WSD (See *6 on P. 214) ports and Internet services that use
HTTP protocol can share the same port number.
Connect Time-Out Sets the time after which data reception is canceled if data is not received.
Specify the value from 0 to 65535 seconds in 1-second increments.
• [60 Seconds] (default)
TBCP Filter Sets whether to enable or disable the TBCP filter during processing of
PostScript data.
• [Disabled] (default)
• [Enabled]
Network/Port
EtherTalk Compat
EtherTalk Compat
Port Status
EtherTalk Compat
PJL
Setting Description
Port Status Sets whether to enable or disable the EtherTalk port at printer start-up.
• [Enabled]
• [Disabled] (default)
Important
• If the printer runs out of memory when the port is enabled, the port is
sometimes automatically disabled. If this happens, either disable unused
ports, or change the memory allocation under [Allocate Memory].
PJL Sets whether to enable or disable PJL commands that are sent from the
computer.
PJL commands control print jobs, and are required to print jobs using the print
driver. Use of PJL commands allows you to specify the language emulation for
the next job while another language emulation is being processed by the
printer. (See *5 on P. 214.)
• [Enabled] (default)
•[Disabled]
Setting Description

Fuji Xerox DocuPrint C5005 d Specifications

General

Brand	Fuji Xerox
Model	DocuPrint C5005 d
Category	Printer
Language	English