168 5 Control Panel Settings
[SNTP Settings]
[HTTP-SSL/TLS]
Note
• Set this when encrypting HTTP communication data using the SSL/TLS protocol. [HTTP-SSL/TLS]
appears only when a certificate is registered on the printer.
• For details on encrypting HTTP communication data and a server certificate required for the printer, refer
to “Configuring HTTP Communication Encryption Settings” (P. 358).
• Communication encryption is not supported on the model available in China.
Network/Port
SNTP Settings
SNTP Settings
NTP Synchronize
SNTP Settings
Connect Interval
SNTP Settings
NTP IP Address
Setting Description
NTP Synchronize Sets whether or not to synchronize the time of the printer's machine clock with
that of the NTP server.
• [Off] (default)
•[On]
Connect Interval Sets the interval used for connecting to the NTP server. Specify the value from
1 to 500 hours in 1 hour increments. (See *2 on P. 214.)
• [168 Hours] (default)
NTP IP Address Sets the IP address of the NTP server.
Enter the IP address in the format: xxx.xxx.xxx.xxx. For IP addresses, xxx can
be any number between 0 and 255. (See *2 on P. 214.)
• [000.000.000.000] (default)
Network/Port
HTTP-SSL/TLS
HTTP-SSL/TLS
Enablement
HTTP-SSL/TLS
Port Number
Setting Description
Enablement Sets whether or not to encrypt HTTP communication data using the SSL/TLS
protocol.
• [Disabled] (default)
Disables SSL/TLS communication.
• [Enabled]
Enables SSL/TLS communication.
Port Number Sets the port number from 1 to 65535. (See *2 on P. 214.)
• [443] (default)
Note
• Set only unique port numbers.
To Next Page
Loading...
Need help?
General
