6.7 Error Messages and Error Codes 283
024-742 The number of prints of a job for which booklet is specified with print options exceeds the number
of booklets that can be printed.
Use print options to divide the job so the number of prints is within the allowable range for booklet
or cancel booklets.
024-746 A function (paper size, paper tray, or duplex printing) has been specified that cannot be used in
combination with the specified paper quality.
Check the print data.
024-747 Incompatible print parameters are used. The combination of the specified features such as
Document Size, Paper Size, Paper Tray, 2 sided printing, and Output Tray is incompatible.
024-775 The number of prints of a job for which booklet is specified with print options exceeds the number
of booklets that can be printed.
Use print options to divide the job so the number of prints is within the allowable range for booklet
or cancel booklets.
025-596
025-597
An error occurred with the hard disk.
Replace the hard disk.
026-400 More than two devices are connected to the USB host port.
Disconnect the third or more devices so that the number of connected devices becomes two. If
the error still is not resolved, switch off the machine power, make sure that the display
is blank,
and then switch on the machine power.
026-704 An error occurred during processing DocuWorks documents.
Open the DocuWorks file with DocuWorks or DocuWorks Viewer. From the [File] menu, select
[Print], and then select the print driver to use for printing.
026-705 Unable to process for DocuWorks documents because of insufficient memory space.
Perform one of the following steps.
In the [Print setting] dialog box of ContentsBridge Utility, change the [Print Mode] setting as
follows:
• When [High Quality] is selected, change the value to [Standard], or [Standard] is selected,
change the value to [Fast].
• Install the additional system memory (optional) to increase the capacity of memory.
• Open the DocuWorks file with DocuWorks or DocuWorks Viewer. From the [File] menu, select
[Print], and then select the print driver to use for printing.
026-706 Attempted to print a DocuWorks document of which printing is prohibited.
Release the print prohibited settings using DocuWorks Viewer, and then execute the operation
again.
Refer to
• DocuWorks manual
026-707 When processing password-protected DocuWorks documents, the password entered does not
match that of the DocuWorks document.
Set the correct password on this printer or ContentsBridge Utility.
Note
• Refer to the “ [XDW (DocuWorks)]” (P. 145) to change [XDW(DocuWorks)] setting on the
control panel when directly printing DocuWorks file without ContentsBridge Utility.
026-718 Incompatible print parameters are used. The combination of the specified features such as
Document Size, Paper Size, Paper Tray, 2 sided printing, and Output Tray is incompatible.
Confirm the print data, and try printing again.
026-724
026-725
The communication with the EP server has been failed.
Switch off the machine power, make sure that the display is blank, and then switch on the
machine power.
If the error still is not resolved, contact our Customer Support Center.
026-726 The machine configuration information at a print job specification does not match the actual
machine configuration.
Modify the machine configuration information in the print driver screen to match the actual
machine configuration.
Error Code Cause/Remedy
To Next Page
Loading...
