A.7 Installing the Feature Enhance Kit 415
Press the control board in as far as it will
go.
9. Tighten the three screws to secure the
control board in place.
10. Connect the power cord to the printer.
Turn on the printer’s main power switch and power switch.
The installation is now complete.
Next, continue from step 11 enable the Feature Enhance Kit feature from the control panel.
Important
• Once you install the Feature Enhance Kit and enable it with the control panel, that Feature Enhance Kit
is not usable on any other printer.
11. Press the <Settings> button on the control
panel to display the menu screen.
12. Press the < > button until [Admin Menu] is
displayed.
13. Press the < > or <OK> button to select.
[Network/Port] is displayed.
14. Press the < > button until [System
Settings] is displayed.
15. Press the < > or <OK> button to select.
[Alert Tone] is displayed.
16. Press the < > button until [Software
Options] is displayed.
screw
Settings
LanguageEmulation
Settings
Admin Menu
Admin Menu
Network/Port
Admin Menu
System Settings
System Settings
Alert Tone
System Settings
Software Options
To Next Page
Loading...
Need help?
General
