Fuji Xerox DocuPrint CP315 dw User Manual

3 Using Your Printer
53
▌
[Administrator Menu] > [Network Setup] >
[PS Data Format]
Specifies the PostScript 3 Compatible communication protocol. The change becomes effective after the printer
is restarted.
▌
[Administrator Menu] >
[USB Settings]
Use this menu to change printer settings affecting a USB port.
▌
[Administrator Menu] > [USB Settings] >
[Port Status]
Specifies whether to enable the USB port of the printer. The change becomes effective after the printer is
restarted.
▌
[Administrator Menu] > [USB Settings] >
[PS Data Format]
Specifies PostScript 3 Compatible communication protocol. The change becomes effective after the printer is
turned off and then on again.
▌
[Administrator Menu] > [USB Settings] >
[Job Time-out]
Specifies whether to specify the amount of time the printer waits for data to arrive from the computer. The print
job is canceled if the time-out time is exceeded.
▌
[Administrator Menu] >
[System Settings]
Use this menu to configure the power saving mode, warning tones, time-out duration, and job log auto print
settings.
▌
[Administrator Menu] > [System Settings] >
[Power Saver Time]
Specifies the time for transition to power saver mode.
[Auto]
Used when auto-detecting the PostScript 3 Compatible communication
protocol.
[Standard]
Used when the communication protocol is in ASCII interface.
[BCP]
Used when the communication protocol is in binary format.
[TBCP]
Used when the communication protocol supports both ASCII and binary data
to switch between them according to the specified control code.
[Binary]
Used when no special processing is required for data.
[Auto]
Used when auto-detecting the PostScript 3 Compatible communication
protocol.
[Standard]
Used when the communication protocol is in ASCII interface.
[BCP]
Used when the communication protocol is in binary format.
[TBCP]
Used when the communication protocol supports both ASCII and binary data
to switch between them according to the specified control code.
[Binary]
Used when no special processing is required for data.
[Low Power Timer]
Specifies the time for the printer to enter the low power mode. The printer
enters this mode when it is not used for the specified time.

Fuji Xerox DocuPrint CP315 dw Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CP315 dw
Category	Printer
Language	English