User Guide
54
When you specify 1 minute for [Low Power Timer], the printer enters the low power mode 1 minute after it has
been idle for the specified time. This uses much less energy, but requires more warm-up time for the printer.
Specify 1 minute if the printer shares an electrical circuit with room lighting and you notice lights flickering.
Select a high value if the printer is in constant use. In most circumstances, this keeps the printer ready to operate
with minimum warm-up time.
Select a medium value if you want a balance between energy consumption and a shorter warm-up period.
The printer returns to the standby mode from the power saver mode when it receives data from a computer. You
can a
lso change
the sta
tus of the prin
ter to the st
andb
y mode b
y press
ing the
<P
o
wer> bu
tton on the
operator panel.
▌
[Administrator Menu] > [System Settings] >
[Auto Reset]
Automatically resets the print settings to the default settings and return to the standby mode after you do not
specify any settings for the specified time.
▌
[Administrator Menu] > [System Settings] >
[Fault Time-out]
Specifies whether to specify the amount of time the printer waits before canceling a job that stops abnormally.
The print job is canceled if the time-out time is exceeded.
▌
[Administrator Menu] > [System Settings] >
[Clock Settings]
Specifies the date and time formats.
▌
[Administrator Menu] > [System Settings] >
[Audio Tones]
Specifies whether to emit a tone during operation or when a warning message appears.
[Sleep Timer]
Specifies the time for the printer to enter the sleep mode after it has entered
the low power mode.
[Set Date & Time] [Time Zone]
Sets the time zone.
[Set Date]
Sets the date depending on the [Date Format] settings.
[Set Time]
Sets the time.
[Date Format] [yy/mm/dd]
Sets the date format.
[mm/dd/yy]
[dd/mm/yy]
[Time Format] [12H]
Sets the time in 12-hour format.
[24H]
Sets the time in 24-hour format.
[Control Panel]
Selects the volume for a tone when the operator panel input is correct.
[Invalid Key]
Selects the volume for a tone when the operator panel input is incorrect.
[Machine Ready]
Selects the volume for a tone when the printer is ready to process a job.
[Job Completed]
Selects the volume for a tone when a job is complete.
[Fault Tone]
Selects the volume for a tone when a job ends abnormally.
[Alert Tone]
Selects the volume for a tone when a problem occurs.
[Out of Paper]
Selects the volume for a tone when the printer runs out of paper.
[Low Toner Alert]
Selects the volume for tone when toner is low.
To Next Page
Loading...
Need help?
General
