Fujitsu Airstage J-II - Page 389

OPERATION MODE button1
Selects the operating mode (AUTO, HEAT, FAN, COOL, DRY).
/Start / end R.C. custom code change. (Max 4 types)
Economy button2
Set temp. button ( ▲ / ▼ )3
Set remote controller custom code buttons
Sets the indoor temp./ Sets R.C. custom code.
Filter reset button4
Sleep button5
Pressed to select sleep timer.
Fan button6
Selects the fan speed (AUTO, LOW, MED, HIGH).
START/STOP button7
Pressed to start and stop operation.
Set button (Vertical)8
Vertical airow direction set button.
Set button (Horizontal)9
Horizontal airow direction set button.
Swing button10
Swing airow button.
Timer mode button11
Pressed to select the timer mode. (OFF TIMER, ON TIMER,
PROGRAM TIMER, TIMER RESET)
Timer set ( + / - ) button12
Sets the current time and on-off time.
Clock adjust button13
Sets the current time.
Reset button14
Used when replacing batteries.
Test run button15
Used when testing the air conditioner after installation.
Signal transmitter16
Temperature set indicator17
Economy indicator18
Operating mode indicator19
Sleep indicator20
Transmit indicator21
Fan speed indicator22
Swing indicator23
Timer mode indicator24
Clock indicator25
FUNCTIONS

Display panel
*1 : "AUTO " is not available for a heat pump model unless it is set up as an administrative indoor
unit.
*2 : "FAN " is not available for a heat pump model.
*3 : "HEAT " is not available for a cooling only model.
2
4
9
3
1
16
15
5
10
13
11
12
14
8
7
6
17
18
19
21
24
23
22
25
20
- (05 - 85) -
CONTROL SYSTEM CONTROL SYSTEM