Fujitsu Airstage J-II - Page 426

Filter mode setting
z
Set the Filter mode to suppress an increase of the amount of communication information in the VR-II system.
Filter mode is turned on by inserting the accessory connecting wire at the CN4 connector on the PC board. ●
When the Filter mode setting is changed, turn the power off once. Otherwise, the setting will not be recognized. ●
CN4
Body
PC board
Connecting wire (Accessory)
DIMENSIONS

211
241.6
288
2-Ø5
67
89.5
89.5
29
Ø28
For dust proof
bushing
4 - Ø5 For M4×20-mm screws
Ø28
For dust proof bushing
For M4×20-mm
screws
272 Hole pitch
95
Hole pitch
95
Hole pitch
Ø22.2 For conduit
(Unit : mm)
- (05 - 122) -
CONTROL SYSTEM CONTROL SYSTEM