Fujitsu Airstage J-II - Page 539


When setting the manual address.
00 01 0200 00 001
5
2 3
03 04 0500 00 004 0 0
*1
*3
2 wire type R.C.
R.C.line: 2 wire
2 wire type R.C.
*2 *2
000
2 3
100
3
200
3
●Rotary SW setting of Indoor unit
Remote
controller
address
Rotary SW setting
RC AD
0
0
1
1
11
B
15
F
*
1 :
Note: When setting the manual address, can not be set the "0".
*2 : When remote controller group is not constructed (1:1 connection of indoor unit and remote controller), be sure
to set the remote controller address to "0" (factory setting).
*3 : The address can be set from 1 to 32. However, do not set the same number as that for the remote-controller
address of an indoor unit connected using the same remote-control cable.
Please set "Remote controller address" of Wired remote controller (2-wire) in Manual address setting only. It is
not necessary to set in Automatic address setting.
Remote
controller
address
Rotary SW
setting
RC AD
0 0
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
10 A
11 B
12 C
13 D
14 E
15 F
- (07-13) -
FUNCTION SETTING FUNCTION SETTING