PREPARATION
3) Turn on the power to the indoor unit.
By turning on the power indoor units initializes EEV, so make sure the piping air-tight test and ●
vacuuming have been conducted before turning on the power.
Also check again to make sure no wiring mistakes were made before turning on the power. ●
Indoor
units
Indoor
units
SWITCHING SELECTION OF ADDRESS SETTING MODE
4) To activate the address setting mode, hold down the three buttons of "MENU", "<" and
"ENTER" at the same time for 2 seconds or longer.
Address setting mode initial display
5) Select the “13” in Menu 2 Settings. Then press the "ENTER" button.
- (07-41) -
FUNCTION
SETTING
FUNCTION
SETTING
To Next Page
Loading...
