Fujitsu Airstage J-II - Page 568

ADDRESS SETTING

Indoor unit address setting
z
6) Pressing the "+" or "-" button, select a remote controller address (select the indoor unit you
want to operate). Then press the "ENTER" button.
Ex.) When remote controller address “01” is selected
Remote controller address
7) Pressing the "+" or "-" button, display function number 01. Then press the "ENTER" button.
Function number
8) Pressing the "+" or "-" button, set up the indoor unit address. (The setting range is from 00
to 63.)
Ex.) When indoor unit address
data “12” is set up
Indoor unit address
ERROR GOOD
When indoor unit address data was not set ●
up on the indoor unit (-- is displayed.)
Set up indoor unit address data again. ●
When indoor unit address data was normally ●
set up on the indoor unit.
9) Pressing the "ENTER" button to return to the address selection screen. If setting has been
completed, pressing the "MENU" button to return to the Menu 2 item selection screen.
- (07-42) -
FUNCTION SETTING FUNCTION SETTING