Fujitsu Airstage J-II - Page 569

Refrigerant circuit address setting
z
10) Pressing the "+" or "-" button, select a remote controller address (select the indoor unit you
want to operate). Then press the "ENTER" button.
Ex.) When setting at all the indoor units
Remote controller address
11) Pressing the "+" or "-" button, display function number 02. Then press the "ENTER" button.
Function number
12) Pressing the "+" or "-" button, set up the refrigerant circuit address. (The setting range is
from 00 to 99.)
Ex.) When refrigerant circuit
address data “18” is set up
Refrigerant circuit address
GOODERROR
When refrigerant circuit address data was not ●
set up on the indoor unit (-- is displayed.)
Set up refrigerant circuit address data again. ●
When refrigerant circuit address data was ●
normally set up on the indoor unit.
13) Pressing the "ENTER" button to return to the address selection screen. If setting has been
completed, pressing the "MENU" button to return to the Menu 2 item selection screen.
- (07-43) -
FUNCTION SETTING FUNCTION SETTING