Fujitsu Airstage J-II - Page 570

COMPLETION OF ADDRESS SETTING MODE

14) To clear the address setting mode and return to the normal mode display, hold down the
three buttons of "MENU", "<" and "ENTER" at the same time for 2 seconds or longer.
Normal mode display
SETTING UP EACH INDOOR UNIT

0001 0101 0201 1301 1401 15010 0 0 0 0 0
Indoor unit Indoor unit Indoor unit Indoor unit Indoor unit Indoor unit
Repeat the procedures in steps 1) through 14), and set up the indoor units
requiring address setting.
Wired
remote
controller
RESET THE POWER AFTER SETTING UP ADDRESS OF ALL

INDOOR UNITS
Important
If the reset is not performed, address can not be read in normally.
¾
After all the addresses have been set, the circuit breaker needs to be switched off
¾
for at least 2 minutes.
After the 2 minutes has passed, power can be restored.
The set address is stored in the PCB and will remain in memory even when the
¾
power is turned off.
However setting address is effective after power reset.
Record the address set in the indoor unit on a label, etc., and afx the label to the
unit so it can be used for after-sales service operations.
- (07-44) -
FUNCTION SETTING FUNCTION SETTING