Fujitsu Airstage J-II - Page 619

SW1 setting
z
Remote controller wire type setting switch
●
(
u
...Factory setting)
SW1 Remote controller wire type
u
2WIRE 2-wire type
3WIRE 3-wire type
ROTARY SWITCH SETTING

IU AD setting
z
Indoor unit address switch
●
Sets the indoor unit addresses.
Please see "1-3 address setting" for indoor unit address conversion table.
INDOOR UNIT ADDRESS SWITCH (Factory setting IU AD x 1: 0, IU AD x 10: 0)
Rotary SW Description Remarks
IU AD x 1 Indoor unit address Switch 1 Indoor unit address (the rst digit)
IU AD x 10 Indoor unit address Switch 2 Indoor unit address (the second digit)
REF AD setting
z
Refrigerant circuit address switch
●
Sets the refrigerant circuit address.
Please see "1-3 address setting" for refrigerant circuit address conversion table.
REFRIGERANT CIRCUIT ADDRESS SWITCH (Factory setting REF AD x 1: 0, REF AD x 10: 0)
Rotary SW Description Remarks
REF AD x 1 Refrigerant circuit address Switch 1 Refrigerant circuit address (the rst digit)
REF AD x 10 Refrigerant circuit address Switch 2 Refrigerant circuit address (the second digit)
- (07-93) -
FUNCTION SETTING FUNCTION SETTING