U41842-J-Z125-1-76 25
Dokuschablonen qua19x24 Version 1.1us für FrameMaker V7.x vom 25.03.2010 © cognitas GmbH 2001-2010
1. April 2010 Stand 11:05.39 Pfad: G:\allgemein\CS800\1000500_FTS-Doku\1000502_GettingStartedGuide\GettingStarted.k04
Installing an ETERNUS CS800 Rack
Notes on Safety
V
CAUTION!
● The activities described in this chapter may only be performed by technicians,
service personnel or technical specialists. Ignoring the instructions in this
manual can result in personal injury or damage to equipment (risk of tipping
over, etc.).
● When the unit is transported, it may be tilted at most by 30°.
● The unit must remain in the original package until it has reached its installation
location.
● Make sure the floor at the final place of installation has sufficient load-bearing
capacity.
● Always ensure that the anti-tilt plate is mounted when you set up the ETERNUS
CS800 Rack (risk of tipping over).
● Route cables in such a way that they do not form a potential hazard (make sure
no one can trip over them) and that they cannot be damaged.
● For safety reasons, not more than one unit may be pulled out of the rack at
a time, otherwise the rack may tip over.
This is illustrated by the following pictogram:
● For safety reasons, not more than one unit may be withdrawn from the rack at
any one time during installation and maintenance work.
If more than one unit is withdrawn from the rack at any one time, there is a
danger that the rack will tilt forward.
To Next Page
Loading...
Need help?
General