Necessary Tools Preparing the Installation of ETERNUS CS800 Components
38 U41842-J-Z125-1-76
Necessary Tools
Provide the following tools for unpacking and installing the ETERNUS CS800 system:
● #2 Phillips and Torx 20 screwdriver
Taking ESD Precautions
Some components within the ETERNUS CS800 system contain static-sensitive parts. To
avoid damaging these parts while performing installation procedures, always observe the
following precautions:
● Keep the ETERNUS CS800 system turned off during all installation procedures.
● Keep static-sensitive parts in their original shipping containers until ready for instal-
lation.
● Do not place static-sensitive parts on a metal surface. Place them inside their protective
shipping bag or on an antistatic mat.
● Avoid touching connectors and other components.
I
Dry climates and cold-weather heating environments have lower relative
humidity and are more likely to produce static electricity.
Unpacking the ETERNUS CS800
By following these instructions, you help ensure that the system will continue to be
safeguarded after it arrives at the installation site.
V
CAUTION!
Do NOT discard the packing materials after the system is unpacked. The packaging
materials must be used if the system is relocated.
W
WARNING!
The RX300 S5 server and DX80 basic module weighs 55 lbs (25.0 kg) and 77 lbs
(35.0 kg) respectively. Two people are required to lift either chassis.
To Next Page
Loading...
Need help?
General