Installing the ETERNUS CS800 Components Installing the CS800 System in the Rac
U41842-J-Z125-1-76 55
Dokuschablonen qua19x24 Version 1.1us für FrameMaker V7.x vom 25.03.2010 © cognitas GmbH 2001-2010
1. April 2010 Stand 11:05.09 Pfad: G:\allgemein\CS800\1000500_FTS-Doku\1000502_GettingStartedGuide\GettingStarted.k06
Installing the Module
1. Install the DX80 module to the rack.
W
CAUTION!
● When installing the DX80 module to the rack, make sure to have the right and
left sides and the bottom of the controller enclosure by two or more people.
Failure to do so may cause injury.
● Two pieces of tape are attached to the top of the DX80 module. Make sure that
this tape does not come off.
Figure 33: Tapes on the top of the DX80 module
2. Fasten the DX80 module in the rack.
Use the two thumb screws at the front of the DX80 module to fasten it in the rack.
Figure 34: Fasten the DX80 module in the Rack
To Next Page
Loading...
