Installing an ETERNUS CS800 Rack Handling Instructions
U41842-J-Z125-1-76 31
Dokuschablonen qua19x24 Version 1.1us für FrameMaker V7.x vom 25.03.2010 © cognitas GmbH 2001-2010
1. April 2010 Stand 11:05.39 Pfad: G:\allgemein\CS800\1000500_FTS-Doku\1000502_GettingStartedGuide\GettingStarted.k04
Figure 7: Adjusting the PRIMECENTER Rack
● Make sure that the four installation plates have been fixed to the leveling feet.
● Adjust the PRIMECENTER Rack using the Allen key supplied.
The leveling feet are easy to adjust when not carrying the full weight of the rack. If
necessary, please ask another person to tilt the rack slightly in order to relieve the
leveling foot in question.
● Raise the leveling feet such that the anti-tilt plate can be easily pushed in underneath.
I
The horizontal orientation of the rack is required to ensure the pull-out functions of
the components mounted to the rack.
I
The rack is set up properly, as a rule, when the front panels of the mounted
components add up to form a continuous vertical line!
To Next Page
Loading...
