Fujitsu ETERNUS DX100 S3 - Page 102

4 Wear a wrist strap or touch a metal part to discharge the human body's natural static electricity.
5 Disconnect the FC cable that is connected to the FC port in the Short wave SFP+ module (16Gbit/s) that
is to be replaced.
Push the tab on the FC cable connector and pull out the cable.
Make sure to record the connecting port for the disconnected FC cable.
6 Remove the Short wave SFP+ module (16Gbit/s).
(1) Open the Short wave SFP+ module (16Gbit/s) lever upward.
(2) Pull the Short wave SFP+ module (16Gbit/s) straight out of the port cage.
Make sure to store the removed Short wave SFP+ module (16Gbit/s) with the fixing lever and the
connector cover attached.
7 Install the Long wave SFP+ module (16Gbit/s).
(1) Remove the connector cover attached to the port of the Long wave SFP+ module (16Gbit/s) and
open the lever.
SFP+ module
Lever
Keep the removed connector cover in a safe place where they will not be lost.
(2) Check the direction of the Long wave SFP+ module (16Gbit/s) and insert it all the way into the
port gauge.
(3) Close the Long wave SFP+ module (16Gbit/s) lever downward.
8 Connect the FC cable that is disconnected in Step 5.
Connect the FC cable connector to the FC port on the Long wave SFP+ module (16Gbit/s).
Chapter 5
Component Expansion/Function Enhancement
5.3 Installing Long Wave SFP+ Modules (16Gbit/s)
102
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0