● LAN Card Replacement
The following procedure explains how to replace the LAN card.
1 Turn off the server where the LAN card is to be replaced.
2 Replace the LAN card.
For details on the replacement procedure, refer to the relevant documentation for the LAN card.
3 After completing the settings, confirm that access from the server is available.
● SAS Card Replacement
The following procedure explains how to replace the SAS card.
1 Check the SAS address, the host affinity and the other settings of the SAS card that is to be removed
from ETERNUS Web GUI or ETERNUS CLI, and then record the settings.
2 Replace the SAS card on the server.
(1) Turn off the server where the SAS card is to be replaced.
(2) Replace the SAS card.
For details on the replacement procedure, refer to the relevant documentation for the SAS card.
3 Change the SAS address, host affinity, and other settings of the removed SAS card.
Set the SAS address, host affinity, and other settings of the new SAS card by referring to the information
recorded in Step 1.
4 After completing the settings, confirm that access from the server is available.
Chapter 7
Troubleshooting
7.1 Check List
119
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0
To Next Page
Loading...
