(2) Insert the drive all the way into the slot, making sure that it is firmly seated and that the lock
lever is still left open.
• Hold the drive with both hands to protect against jarring.
(3) Swing the lock lever in the direction of the arrow, until the lock clicks shut.
(4) Check that the newly installed drive's DRIVE READY LED lights up green.
5 To install more additional drives, repeat Step 3 and Step 4.
6 If a wrist strap is used, remove the wrist strap.
7 In the [Drives] screen of [Component] on the ETERNUS Web GUI screen, check that the added drives
have been recognized.
8 Set up RAID groups, volumes, hot spares, and host affinity settings, as required.
Chapter 5
Component Expansion/Function Enhancement
5.1 Installing Additional Drives
71
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0
To Next Page
Loading...
