Insert the M4 screws in the second holes on the front and rear rack pillars above the base
line to fasten the rack rails.
High-density drive enclosure
Front/Rear
4U
Rack rail
High-density drive
enclosure base line
[Right][Left]
2nd hole
(M4 screw)
2nd hole
(M4 screw)
(3) Install the stopper bracket.
Attach the stopper bracket to the front rack pillar.
Stopper bracket
(left)
(Rack pillar: front)
Rack rail
(right)
Rack rail
(left)
M5 screw
M5 screw
(Rack pillar: rear)
Stopper bracket
(right)
The M5 screw positions for the stopper brackets are determined by the high-density drive enclo-
sure base line.
Insert the M5 screws in the seventh holes above the base line to fasten the stopper brackets.
4U
Rack rail
High-density drive
enclosure base line
7th hole
(M5 screw)
High-density drive enclosure
Front
[Right][Left]
7th hole
(M5 screw)
Chapter 5
Component Expansion/Function Enhancement
5.2 Installing Additional Drive Enclosures
89
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0
To Next Page
Loading...
