(4) Install the flap brackets.
Attach flap bracket A and B on the right side of the rear rack pillar with the M4 screws.
M4 screw
(Rack pillar: front)
(Rack pillar: rear)
Rack rail
(left)
Rack rail
(right)
Stopper bracket A
Stopper bracket B
The M4 screw positions for flap bracket A and B are determined by the high-density drive enclo-
sure base line.
Insert the M4 screws in the seventh and eighth holes above the base line to fasten the flap
brackets.
4U
Rack rails
High-density drive
enclosure base line
7th & 8th
holes
(M5 screws)
Rear view of a high-density drive enclosure
[Right][Left]
Flap bracket B
(5) Install the high-density drive enclosure in the rack.
- For safety and stability, use a lifter to install or remove high-density
drive enclosures in the rack.
Chapter 5
Component Expansion/Function Enhancement
5.2 Installing Additional Drive Enclosures
90
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0
To Next Page
Loading...
