CHAPTER 5 PRIMEPOWER400 Rackmount (4U) Server
5.2.3 Rear side
The names and functions of parts on the rear of the PRIMEPOWER400 Rackmount (4U) Server are as follows.
(1) AC power input
(2) PCI slots
(3) RCI port
(4) UPS port
(5) Power control port (6) 100Base-TX port
(7) Keyboard port
(8) Serial port B
(9) Serial port A
Figure 5.4 Rear of PRIMEPOWER400 Rackmount (4U) Server
(1) AC power input
Connect the power cable to this point.
(2) PCI slots
PCI slots conform to the PCI local bus specifications (Rev. 2.1).
64-bit bus, 33MHz (5.0 V) and 33/66MHz (3.3V) are supported.
Both short cards (17.46 cm, 6.87 in.) and long cards (31.19 cm, 12.3 in.) are supported.
(3) RCI port (label : RCI)
RJ11 connector for connecting the RCI cable and terminator (provided with the server unit)
(4) UPS port (label : UPS)
Dsub-9 pin for connecting the signal cable of an uninterruptible power supply
(5) Power control port (label : PC)
8-pin DIN for power control
(6) 100Base-TX ports (label : LAN)
RJ45 connector automatically recognizes 10Mbps/100Mbps
(7) Keyboard port (label : KB)
8-pin DIN port for connecting a keyboard cable
(8), (9) Serial port (label : SERIAL A/B)
Dsub-25 pin ports for connecting a console terminal when performing maintenance on the server
unit using the RS-232C interface
72
To Next Page
Loading...
