4.2 Names and Functions of Parts
4.2.3 Rear side
The names and functions of parts on the rear of the PRIMEPOWER400 Pedestal Server are as follows.
(1) AC power inputs
(2) PCI slots
(5) RCI port
(4) UPS port
(3) Power control port
(9) 100Base-TX port
(8) Keyboard port
(6) Serial port A
(7) Serial port B
Figure 4.4 Rear of PRIMEPOWER400 Pedestal Server
(1) AC power inputs
Connect the power cables to these points. Both AC power cords must be plugged into the same
power grid / circuit.
(2) PCI slots
PCI slots conform to the PCI local bus specifications (Rev. 2.1).
64-bit bus, 33MHz (5.0 V) and 33/66MHz (3.3V) are supported.
Both short cards (17.46 cm, 6.87 in.) and long cards (31.19 cm, 12.3 in.) are supported.
(3) Power control port (label : PC)
8-pin DIN for power control
(4) UPS port (label : UPS)
Dsub-9 pin for connecting the signal cable of an uninterruptible power supply
(5) RCI port (label : RCI)
RJ11 connector for connecting the RCI cable and terminator (provided with the server unit)
51
To Next Page
Loading...
