Fujitsu Primepower200 - DAT Drive (DDS4) Operations

CHAPTER 11 Internal I/O Units
11.4 DAT Drive (DDS4)
Note: DDS4 DAT drive can not be installed in the Expansion File Unit Type-2.
This section describes the following items:
 Names and functions of parts
 SCSI ID
 OS settings
 Data cartridges
 Data cartridge handling precautions
 Write-protecting data cartridges
 Loading data cartridges
 Ejecting data cartridges
 Cleaning the tape heads
11.4.1 Names and functions of parts
The following describes the names and functions of individual components of the DDS4 DAT drive.
Figure 11.5 shows the front panel of the DAT Drive.
(1) Tape LED
(2) Clean LED
(3) Eject Button
(4) Data Cartridge slot
Figure 11.5 Front Panel of DDS4 DAT Drive
(1) Tape LED
This LED lights up (green) when a data cartridge is loaded, and blinks (green) when the DAT drive
is operating.
For details, see Table 11.4 .
(2) Clean LED
When this LED starts blinking, the head of the DAT drive should be cleaned using a cleaning
cartridge, or the data cartridge or the cleaning cartridge is near the end of its useful life.
The Clean LED also lights up (amber) if the DAT drive malfunctions.
For details, see Table 11.4 .
198