11.4 DAT Drive (DDS4)
Table 11.4 DAT Drive LED Indicators
LED DAT Drive Status
Tape Clean
Dark Dark
Data cartridge is not loaded.
Lit
Data cartridge is loaded.
Tape is loading / unloading, or drive-diagnostics are
running.
Blinking
(1/2sec interval)
Accessing tape ( Read / Write )
(any)
Lit
Drive has malfunctioned.
Blinking
(1/2sec interval)
Tape head cleaning is required, or needs replacing.
Blinking
(1/4sec interval)
(3) Eject Button
CAUTION
Data Destruction
Do not press the Eject button during operation (when the tape LED
is blinking). If the Eject button is held down for about five seconds,
the forced ejection function will execute, and any data being written
may be lost.
Press the Eject button to remove the data cartridge. Before removing a data cartridge, make sure
that the tape LED is out.
If the DAT Software (or operating system) has disabled removal of a data cartridge, the cartridge
cannot be removed by pressing the Eject button.
(4) Data Cartridge Slot
CAUTION
Never insert your fingers or other foreign objects in the data
cartridge slot, as this may damage the unit or cause data to be lost.
11.4.2 SCSI ID
Set the SCSI ID of the DAT drive to "5".
199
To Next Page
Loading...
