Fujitsu Primepower200 - Figure 4.8 PRIMEPOWER400 Pedestal Server PCI Boards; Adding Power Supply Units

CHAPTER 4 PRIMEPOWER400 Pedestal Server
PCI slot #10
PCI slot #9
PCI slot #8
PCI slot #7
PCI slot #6
PCI slot #5
PCI slot #4
PCI slot #3
PCI slot #2
PCI slot #1
PCI Board #1
PCI Board #2
Figure 4.8 PRIMEPOWER400 Pedestal Server PCI boards
4.4.1 Adding power supply units
IMPORTANT
Adding an optional redundant power supply unit allows hot-swapping of the power supply units.
CAUTION
Unit Damage
Power supply units may be damaged if hot-swapping of the power supply units is
not performed correctly. Contact the service engineer if a power supply unit must
be hot-swapped.
Power supply units (FEP) installed on the PRIMEPOWER400 Pedestal Server are hot-swappable. To enable
hot-swapping, use the tools (machine administration) contained in the "Enhanced Support Facility" to perform
62