7.2 Names and Functions of Parts
7.2.3 Rear side
The names and functions of parts on the rear of the PRIMEPOWER600 Pedestal Server are as follows.
(2) AC power inputs
(3) Base PCI slots
(7) RCI port
(6) UPS port
(5) Power control port
(11) 100Base-TX port
(10) Keyboard port
(8) Serial port A
(9) Serial port B
(4) Expansion PCI slots
(option)
(1) AC power inputs
Figure 7.4 Rear of PRIMEPOWER600 Pedestal Server
(1), (2) AC power inputs
Connect the power cables to these points. Both AC power cords must be plugged into the same
power grid / circuit.
(3) Base PCI slots, (4) Expansion PCI slots (option)
PCI slots conform to the PCI local bus specification (Rev. 2.1).
64-bit bus, 33MHz (5.0 V) and 33/66MHz (3.3V) are supported.
All RCI support long cards (31.19 cm, 12.3 in.).
(5) Power control port (label : PC)
8-pin DIN for power control
(6) UPS port (label : UPS)
Dsub-9 pin for connecting the signal cable of an uninterruptible power supply
(7) RCI port (label : RCI)
RJ11 connector for connecting the RCI cable and terminator (provided with the server unit)
121
To Next Page
Loading...
