EasyManua.ls Logo

Fujitsu Primepower200 - CD-ROM Discs; CD-Rom Disc Handling Precautions

Fujitsu Primepower200
272 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11.2 CD-ROM Drive
11.2.2 CD-ROM discs
Only CD-ROM discs with the mark shown in Figure 11.2 can be used in this CD-ROM drive.
Figure 11.2 CD-ROM Disc Mark
11.2.3 CD-ROM disc handling precautions
CAUTION
Do not scratch the surface of a CD-ROM disc. Pay special attention when
removing a CD-ROM disc from its case.
Do not widen the center hole of a CD-ROM disc.
Do not write on a CD-ROM disc with a ball-point pen or pencil.
Do not clean a CD-ROM disc with benzene, paint thinner, water, record
spray, or an antistatic agent.
Do not expose a CD-ROM disc to heat or sunlight.
Do not store a CD-ROM disc in a place that undergoes rapid changes in
temperature or humidity.
If a CD-ROM disc is not being used, remove it from the CD-ROM drive, and
store it in its case to protect it from dust, scratching and breakage.
189

Table of Contents

Related product manuals