Fujitsu Primepower200 - Hot-swapping Redundant Components

10.5 Hot-swapping Redundant Components
#1 #2
#3
#4 #5 #1 #2
#3
#4 #5
ACTIVE LED (Green)
FAULT LED (Amber)
Base SCSI Unit
File Unit Expansion Kit
Figure 10.3 Full Disk Drive Configuration of Expansion File Unit Type-2
#1 #2
#3
#4 #5
#2
#1
ACTIVE LED (Green)
FAULT LED (Amber)
Base SCSI Unit
Expansion Tape Unit
Figure 10.4 Disk Drive + Tape Drive Configuration of Expansion File Unit Type-2
10.5 Hot-swapping Redundant Components
This section describes hot-swapping of redundant components.
10.5.1 Power supply units
CAUTION
Unit Damage
The unit may be damaged if hot-swapping of power supply units is not
performed correctly. Contact the service engineer if a power supply unit must be
hot-swapped.
183