2.2 Names and Functions of Parts
(1) AC main line switch
The PRIMEPOWER200 Pedestal Server is turned on by the POWER switch on the front of the
server unit when this switch is set to the "|" position.
(2) AC power input
Connect the power cable to this point.
(3) PCI slots
PCI slots conform to the PCI local bus specification (Rev. 2.1).
64-bit bus, 33MHz (5.0 V) and 33/66MHz (3.3V) are supported.
Both short cards (17.46 cm, 6.87 in.) and long cards (31.19 cm, 12.3 in.) are supported.
(4) Power control port (label : PC)
8-pin DIN for power control
(5) UPS port (label : UPS)
Dsub-9 pin for connecting the signal cable of an uninterruptible power supply
(6) RCI port (label : RCI)
RJ11 connector for connecting the RCI cable and terminator (provided with server unit)
(7), (8) Serial ports (label : SERIAL A/B)
Dsub-25 pin ports for connecting a console terminal when performing maintenance on the server
unit using the RS-232C interface
(9) Keyboard port (label : KB)
8-pin DIN port for connecting the keyboard cable
(10) 100Base-TX port (label : LAN)
RJ45 connector automatically recognizes 10Mbps/100Mbps
9
To Next Page
Loading...
