Fujitsu Primergy RX100 S2 User Manual

142
Chapter 5 Operations after OS Installation
■ Starting ServerStart
● For Creation on a Client Computer
When the CD has been copied on Windows 2000 Professional/Windows XP
Professional
1 Click [Start] → [Programs] → [Fujitsu ServerStart] → [ServerStart].
ServerStart starts up and the [Welcome to ServerStart] window appears.
When Windows NT is used, or if the CD has not been copied
1 Insert the ServerStart CD-ROM into the client computer's CD-ROM drive.
ServerStart starts up and the [Welcome to ServerStart] window appears.
● For Creation on the Server
1 Turn on the server and insert the ServerStart CD-ROM immediately.
ServerStart starts up and a message appears prompting you to insert the ServerStart floppy disk.
2 Insert the attached "ServerStart floppy disk" into the server's floppy disk drive.
Then make sure "Removable media" and "A:" are selected and click [Create].
A network setup window for remote installation appears.
 If a configuration file already exists in the ServerStart floppy disk and [OK] is clicked without
clicking [Create], the [ServerStart Unattended Mode] window appears. Make sure to click
[Exit]. The [Welcome to ServerStart] window appears.
If [Start] is clicked in the [ServerStart Unattended Mode] window, the installation of the server
will start and all disk contents will be deleted.

Fujitsu Primergy RX100 S2 Specifications

General

Brand	Fujitsu
Model	Primergy RX100 S2
Category	Server
Language	English