194
Chapter 8 Hardware Configuration/Utilities
8.2.2 Main Menu
The [Main] menu window is initially displayed when you start the BIOS Setup Utility.
Settings for time and date and for the drives are configured in the [Main] menu window.
table: Items on the Main Menu
Item Setting Description
System Time Present time The system time is set in "hours:minutes:seconds"
format. The hours should be based on a 24-hour
clock.
For example, 6:30:00 P.M. is set as "18", "30",
"00".
Note:
ī Repeat the procedure until the correct time
is set.
If a highly precise system time is necessary,
install a network synchronized time system
(NTP, etc.).
System Date Present date The system date is set in "month:day:year" format.
For example, August 20, 2005 is set as "08", "20",
"2005".
Diskette A 1.44/1.25MB 3 1/2"
(Fixed parameter)
Specifies the type of floppy disk drive A (recording
density and drive size).
Parallel ATA [Enter] Sets the type and operating mode for the connected
internal hard disk unit.
ī"8.2.3 Parallel ATA Submenu" (pg.195)
SATA Port 0 [Enter] This server does not use this port.
SATA Port 1 [Enter]
Boot Options [Enter] Sets system startup options.
ī"8.2.4 Boot Options Submenu" (pg.197)
Base Memory - Available base memory size of up to 1MB is
displayed.
Extended Memory - Memory size of 1MB or more is displayed.
Advanced Security Server Exit
System Time: [HH:MM:SS]
System Date: [MM:DD:YYYY]
Diskette A: [1.44/1.25 MB 3
1/2"]
Parallel ATA [SR244W]
SATA Port 0 [Auto]
SATA Port 1 [Auto]
Boot Options
Base Memory:
640 KB
Extended Memory:
260608 KB
PhoenixBIOS Setup Utility
Item Specific Help
Main
Select Sub-Menu
F1
Esc
Select Item
Select Menu
Change Values-/+
Enter
Info
Exit
F9
F10
Setup Defaults
Save and Exit
To Next Page
Loading...
Need help?
General