Fujitsu Primergy RX100 S2 - Open;Create a Configuration File

58
Chapter 3 OS Installation Using ServerStart
3.1.2 Open/create a Configuration File
Open a configuration file. Or create a new file.
1 Click [Start here to create a complete configuration file].
The [Open ServerStart Configuration File] window appears.
 Once a configuration file is opened, another file cannot be opened until you click [Close and
save Configuration File].
2 Select the configuration file and click [Create].
The next wizard starts up automatically.
If the array controller is installed or if the Preconfiguration mode is selected
The RAID Wizard starts up. Go to "3.1.3 RAID Wizard" (pg.59).
If an array controller is not installed
The Disk Wizard starts up. Go to "3.1.4 Disk Wizard" (pg.60).