Installing the second HDD backplane
▶
Install the second HDD backplane, see "Installing the new 4x 2.5-inch HDD
backplane" on page 161.
▶
If applicable, install a dual-channel RAID controller
, see "Installing an
expansion card" on page 196.
▶
Depending on your configuration, connect all required cables to the HDD
backplane.
▶
If an ODD has been removed, install the ODD again, see "Installing the
ODD" on page 258.
Installing additional HDD/SSD modules
▶
Remove the dummy locks, see "Removing the 2.5-inch dummy module" on
page 153.
▶
Insert additional HDD/SSD modules, see "Installing 2.5-inch HDD/SSD
modules" on page 152.
Concluding steps
▶
"Reassembling" on page 52.
▶
"Connecting the power cord" on page 56.
▶
"Switching on the server" on page 58.
▶
Update the system information of your server using the Chassis ID Prom
Tool, see "Using the Chassis ID Prom Tool" on page 91. Select the
corresponding system name.
▶
"Performing a RAID array rebuild" on page 87.
Hard disk drive (HDD) / solid state drive (SSD)
RX1330 M4 Upgrade and Maintenance Manual 175
To Next Page
Loading...
